Free nikon digital slr software for mac

mini Digital Clock is a smaller version of the Yahoo! Digital Clock Widget that ships with Konfabulator. Its a fraction of the size, features a new alarm chime, and offers four themes to choose from.

System requirements:
-

Enhancements
- Initial Release

There are lots of strange clocks for Dashboard, but pretty much all of them are very small, which isnt suited for a Media Mac, where youre looking at the clock from a couple of feet away in your sofa.

So I made two large clocks for Dashboard running on a MediaMac; An analog and a digital one. Both are about 400 pixels wide so theyre easy to see from across the room.

Nothing fancy about them. No city support, not even seconds are shown and no preferences to set.

Customize your iPhone using this beautiful theme.
System requirements:
- iPhone

24 hr. Digital Clock is as the name says a LCD-type display digital clock. Time is displayed in 24 hour format.

Completly freeware for non-commercial use.

If you have a widget covering your clock, to check the time you must close Dashboard look at your clock then open Dashboard up again- this is the solution: a big digital clock that is displayed ON your Dashboard. Emory Dunn Digital Clock is big enough to be seen even from across the room, so if you have your Dashboard open a lot you will never need to go and buy a clock.

Enhancements
- New image colors: every single one.

Nikon D2X - Firmware update for the Nikon digital camera.
Enhancements:
- Autofocus performance has been increased.
- An issue that prevented the AF-assist illuminator from firing when the Speedlights listed below were used has been corrected. Speedlights effected: SB-29s, SB-29, SB-23, SB-22s, SB-22, SB-20
- In images captured at a shutter speed of 1/250 s with a Speedlight SB-800, set to Distance-priority manual flash (GN), or Manual flash (M) with flash output set to full (M1/1) mounted on the camera, the top portion was often dark. This issue has been addressed. However, under the circumstances described above only, the guide number is reduced from that of full flash output level by approximately 0.6 EV.
- Images captured at white-balance settings of Incandescent, Direct sunlight, Cloudy, Shade, and Choose color temp. tended to have a reddish tint. This issue has been addressed.
- Errors in Dutch menus have been corrected.
The basic steps to update the firmware are:
1. Download and expand the firmware files
2. Format an approved CF card in the camera (do not use a Microdrive card to perform this update)
3. Connect Camera to computer (in MSC USB mode) or use a CF Card Reader (do not use a Lexar Jump Shot USB cable to perform this update)
4. Copy to the top level of the card the downloaded "A firmware" file
5. Disconnect camera from computer
6. Update the firmware from the "Setup" menu
7. Follow the cameras on-screen menus
8. Repeat steps 2 through 7 using the "B Firmware"
9. Re-format Card
NOTE : The most common mistake which prevents installation is copying both firmware.bin files at the same time. Be sure to do each update separately!

To use Digital Passages RSS screensaver:
1. Place the "Digital_Passages_RSS.qtz" file in ~/Library/Screen Savers/

2. Go to your System Preferences and set your Screen Saver to, "Digital Passages RSS.qtz"

This is a free public version that may be copied and distributed as long as this document and the enclosing folder is completely included as is.