Free g broadband router wrt54gs software for mac

Linksys WRT54GS v2 router Firmware updater.
Instructions :
Before you start, be sure you are using a PC that is connected to the WRT54GS via a wired (Ethernet) connection.
2) Open your web browser (e.g., Internet Explorer, Netscape, etc.)
3) In the Address bar, type in the IP address of your router. The default IP address is 192.168.1.1.
4) Leave the username blank and enter your password. The default password is "admin", all lower case.
5) Click on the Administration tab.
6) Click on Firmware Upgrade.
7) Browse for the firmware file that you have just extracted. The file name should end in .rmt
8) Click the Upgrade button.
9) The router will begin its upgrade routine. Do not power off or unplug the router until the process is completed. This process may take up to 5 minutes to complete.
Enhancements:
- Resolves issue with setup wizard
- Updated wireless security tab
- Resolves issue with port based QoS.

The Broadband Tuner allows you to take full advantage of very high speed Internet connections that have a high latency (5 Mbps or faster). The installer tweaks some system parameters.

There is an optional uninstaller that can be used to restore the settings that were in effect at the time just before the system parameters were changed.

The installer increases the default values for the size of the TCP send and receive buffers. With larger buffers more data can be in transit at once. A startup configuration file is also updated so that these changes will persist across restarts.

The system parameters are sysctl variables that are set as follows:

net.inet.tcp.sendspace: 131072
net.inet.tcp.recvspace: 358400
kern.ipc.maxsockbuf: 512000

This change has a system wide effect and is applied even if the network is not high speed connection with a high latency, with the exception of modem connections for which the system uses small default TCP buffer sizes.

This download supports: English.

When you establish a VPN connection, VPN Router will add static routers to the router table.

Youll be able to define a list of remote IP addresses to which traffic should be routed by VPN tunnel.

Requirements:
Linksys EtherFast 8-Port Cable/DSL Router.

Enhancements:
Version 2.44 fixes the following:

• Added AOL Parental controls support
• Fixed Multicast rebooting router.
• Fixed when UPnP still working when disabled.
• Fixed traceroute not working on the LAN side.
• Fixed the issue of PPTP not being able to connect to the server when more than one DNS setting is entered.
• Fixed PPPoE DNS information overwrite the user defined DNS.
• Updated Static Routing Function.
• Updated Dynamic Routing function.
• Fixed UPnP whiteboard function.
• Added Security by requiring password change for Remote Management.
• Added user defined port number for Remote Management.
• Fixed Lynx connection to the router without Proper Authentication.
• Fixed reboot problem with Long Passwords.
• Fixed CGI script detecting ".xml" and would bypass authentication.
• Removed ZoneAlarm and PC-cillin.

Router IP Address is a small utility for discovering the dynamic IP address assigned by your Internet Service Provider (ISP) when you have a router connecting several computers to a single internet connection (cable modem, DSL, or telephone modem).

Router IP Address is simplicity itself. Just run the program and it displays the IP address that the rest of the Internet sees when you browse or communicate with various service providers. If you have a direct connection to the Internet this number should match that being used by your operating system but if you are using a router or gateway on your local network it will likely be different.

Requirements:
Netopia Router

geeRoute 1.0b1 is a highly-efficient, high-quality software router for Mac OS X users. It works quite similar to the IPNet Router, but it is FREE. It provides you the ip share, nat and firewall option to single ip Internet users.